Filter
Top Products
Introduction
Setting up the 8500
Printer
Operating the 8500
Printer
Troubleshooting
Site Specifications
Accessories and
Supplies
CONTENTS PRINTER DRIVER GUIDE SEARCH HELP
Guide bar
Heater line
Cover head
2. Use a cloth moistened with alcohol to clean the print head,
and wipe along the heater line four times:
Wipe the full length of the area (always in one direction).
Use a clean part of the cloth for each wipe.
Apply firm, even pressure.
Wipe only the following areas.
3. Allow the wiped area to dry for about two minutes.
4. Close the top cover, and turn on the printer.
5. Make a test print. If image quality artifacts are visible on the test
print, repeat Steps 1- 4.
NOTE: It may be necessary to repeat Steps 1- 4 several times to
remove any artifacts. If you cannot remove the artifacts, call
for service.