Filter
Top Products
29
Changing the slide tray
(in zero position)
Removing the slide tray
(in any position)
Fastening or mounting the projector
To reduce vibration or for secu-
rity you will find fixing holes
suitable for inserts (M5) in the
baseplate of the projector (see
figure).
2.
3.
Always lift off the slide tray in the zero
position.
The zero positioning indicator (24)
lights up when the slide tray transport
ring is in the zero position.
Move tray to zero position:
a) Using the slide change button on your
projector or remote control units
Hold the slide transport-backwards button
down. The slide tray goes into rapid search
and stops automatically in the zero posi-
tion.
b) Using the IR Remote Control
Select "0" on the keypad and confirm with
"*". The slide tray moves to the zero posi-
tion.
c) Using the mains switch
Turn the projector off by the mains switch
(34). When the projector is turned on
again, it will complete a system check and
bring the slide tray back to the zero posi-
tion!
In an emergency, e.g. transport failure, the
tray can be removed from the projector in
any position:
First switch off your projector!
1. Push aside and hold the slide tray
lock (14) while -
2. - lifting off the slide tray.
3. Having removed the slide tray turn it
over and rotate the base plate until it locks
into the zero-position, otherwise the slide
tray cannot be replaced on the projector in
the zero position.
. Turn the projector on again. The slide
remaining in the slide gate will be ejected by
the slide lift and can be replaced in the slide
tray.