Filter
Top Products
32
Service
WARNING:
Before pulling out the lamp module, switch off the projector and unplug the mains
lead first!
For lamp replacement let the module cool down before touching the lamp and the
surrounding area. Do not place the hot lampmodule on heat sensitive surfaces.
Glass may shatter. Wear gloves. Keep glass covered.
Do not touch the small bulb or the mirror surface! If you accidentally get finger
prints on them, remove marks with a soft cloth moistened with rubbing alcohol.
Replacement of a defective lamp is very easy with your EKTAPRO Slide Projector:
Replacement of a defective lamp
3. Push the ejector lever completely to
the side.
The defective lamp will come free of its
holder.
4.Remove the defective lamp and in-
sert the new lamp.
. Push the ejector lever back to the right
and press down until it locks into its hold-
ing.
. Push the lamp module back into the
projector until it locks.
1.
2.
3.
4.
1. Press down and hold down the
lamp module release (28) and...
2. ... pull out the lamp module (20).
. Push the lamp ejector lever down
so that it clears the retaining clip.
Note:
For your projection requirements you
have a choice of 3 lamps with different
brightness and lamp life (see Accesso-
ries page 35).
You can either run automatic slide shows
using the built-in timer (EKTAPRO 5020
and 9020) or via the IR remote control using
the Autotimer function (EKTAPRO 7020
and 9020 -in single or in the MASTER/
SLAVE combination). This makes slide
change times between 1 and 60 seconds
possible. For further information please see
under Timer, page 27 or in the separate
manual under "Autotimer".
Note (EKTAPRO 4020/5020/7020
Projector)
In order to avoid "dark pause" it is
recommended that the slide tray is filled
as completely as possible.
KODAK EKTAPRO 9020 Projector
You can immediately bring the tray back to
the zero position after the last slide with the
help of the automatic zero positioning fea-
ture. This is useful when continuous pro-
jection is required using only a few slides.
By pressing the switch (8), you can activate
the automatic zero positioning.
Continuous projection
Service