Filter
Top Products
Using the Projector
3/99 31
Using the On-Screen Menus
The projector has seven drop-down menus that allow you to make
image adjustments and change a variety of settings. Most of these
adjustments aren’t available directly from the keypad.
Note: Some menu items may be grayed out at certain times. This
indicates that the item is not applicable to your setup (for
example, video standards do not apply to computer
sources) or the item is not enabled until another selection is
made (for example, Manual Tracking is not available until
Auto Image is turned off).
To open the on-screen menus, press the button on the
keypad or remote. This changes the volume, source, and standby
buttons on the keypad to menu navigation buttons (and
illuminates the keypad green). Press the corresponding buttons to
move the cursor up, down, left, or right, or use the disk mouse on
the remote. To select a menu, move the cursor left and right to
highlight the menu you want. The drop-down menu appears.
Figure 15 Drop-down menu
To change a menu setting, use the up and down arrow keys on the
keypad or the disk mouse on the remote to move the cursor up
and down to the item you want to change (the selected item is
highlighted red), then use the left and right mouse buttons (not
the left and right arrow buttons) to adjust a setting. Some
submenus, such as Brightness, consist of a slider bar you use to
increase or decrease a value. Some submenus, such as Standby
Time, consist of options you scroll through to select the desired
one. All changes are saved when you close the menus. To access
another menu, use the left and right arrow buttons or the disk
mouse to move left or right to another menu.