Filter
Top Products
Using the Projector
3/99 37
Vertical position
Follow these steps to manually adjust the vertical position.
1. Turn Auto Image off.
2. Highlight Vertical position, then press the left mouse button
to move the image down or press the right mouse button to
move the image up.
Positioning adjustments are saved when you power off the
projector.
Controls Menu
Figure 19 Controls menu
Video Standard
Note: If you already know the video standard used in your
geographical area, it’s often best to manually select it.
When Video standard is set to Auto, the projector attempts to pick
the video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, or
SECAM) automatically based on the input signal it receives. (The
video standard options may vary depending on your region of the
world.) The input signals for SECAM, PAL-M, and PAL-N video
cannot be automatically detected, therefore they must be chosen
manually. If the projector is unable to detect the correct standard,
the colors might not look right or the image might appear “torn.”
If this happens, manually select a standard by clicking either
mouse button and cycling through the standards.