Filter
Top Products
Using the Projector
3/99 39
Plug and Play
This setting toggles between On and Off. When it is On, most
new computers will automatically recognize the projector, then
set the monitor resolution and refresh rate accordingly. You need
to set the Plug and Play setting to Off for the projector to display
properly on some older computers. The Plug and Play setting
does not affect video images.
If the projector’s display constantly changes between the
computer image and the message, “Perfecting the image”, you
may need to set Plug and Play to Off.
Display Messages
This setting toggles between On and Off. When this feature is On,
status messages such as “No signal detected” or “Standby
Active” appear in the lower-right corner of the screen. Click
either mouse button to turn this feature off and not see status
messages.
Display Startup Screen
This setting toggles between On and Off. When this feature is On,
the Kodak startup screen appears when the projector starts up and
remains until an active source is detected. Click either mouse
button to turn this feature off and display a plain black or blue
screen instead of the startup screen.