Filter
Top Products
D-30
2-6. Upgrading the Firmware
NOTES
• The PagePro 1380 MF or The PagePro 1390 MF TWAIN driver and printer driver must
already be installed on the host computer before firmware can be updated.
• If the PagePro 1380 MF or The PagePro 1390 MF TWAIN driver or printer driver is not
installed, follow the procedure described below to install the driver.
• If the drivers are already installed, skip to “Procedure for Upgrading the Firmware” and
upgrade the firmware.
(1) Minimum System Requirements
(2) Install the TWAIN Driver Software
1. Make sure that the machine is not connected to the host computer.
2. Insert the PagePro 1380 MF or The PagePro 1390 MF Utilities & Documentation CD-
ROM into the CD-ROM/DVD drive.
3. The CD-ROM Installer automatically starts.
NOTE
• If the Installer does not automatically start, use Windows Explorer to browse the CD-
ROM and double-click “setup.exe.”
4. Follow the instructions on the screen.
5. Connect the PagePro 1380 MF or The PagePro 1390 MF to the host computer.
6. The “Found New Hardware” (Windows XP/2000) on the host computer shows up.
7. Follow the instructions on the screen.
(3) Install the Printer Driver
1. After installing the TWAIN driver, the “Found New Hardware” (Windows XP/2000) on
the host computer appears.
2. Follow the instructions on the screen.
NOTE
• Do not the “Add Printer” wizard to install the PagePro 1380 MF or The PagePro 1390 MF
driver and utilities.
Operating System
• Windows XP or Windows 2000 (Windows ME/98SE cannot be
used)
Host Computer • Pentium III 500MHz and above, 64 MB RAM