Filter
Top Products
Dual In-Line Memory Module (DIMM)138
2 Using a screwdriver, remove the
screw on the back of the printer.
3 Remove the rear panel.
" Since there are two
hooks on the right side of
the panel, remove the
rear panel by slightly pull
-
ing the left side of the
panel toward you, then
sliding the panel off to the
left.
4 Insert the new DIMM straight
into the DIMM connector until
the latches snap into the locked
position.
Observe the keyed side of the
DIMM to align it with the connec
-
tor. If you cannot snap the DIMM
into place, do not force it. Repo
-
sition it, making sure that the
DIMM is seated completely in
the connector.
5 Reinstall the panel and tighten the screw.
" If you removed the duplex option in step1, reinstall it.