Filter
Top Products
Connecting your Presentation Switcher / Scaler
13
6 Connecting your Presentation Switcher / Scaler
To connect the VP-724xl for example
1
(see Figure 9), do the following
2
:
1. Connect one or more of the following video sources:
2 composite video sources: “AV Source 1” and “AV Source 2”, to the
RCA connectors AV1 and AV2, respectively
2 s-Video sources: “s-Video Source 1” and “s-Video Source 2”, to the 4p
connectors, YC1 and YC2, respectively
A component video
3
source, for example, a “Betacam VCR”, to the 3
RCA connectors, Y, P
b/
C
b
, and P
r/
C
r
4
2 VGA graphics sources
5
: “VGA Graphics Source 1” and “VGA Graphics
Source 2”, to the HD15 connectors VGA 1 and VGA 2, respectively
A DVI graphics source, to the DVI connector
2. Connect the stereo audio sources
6
(not illustrated in Figure 9):
The audio of “CV Source 1” and “CV Source 2” to the AUDIO IN AV1
and AV2 terminal block connectors, respectively
The audio of “s-Video 1” and “s-Video 2” to the AUDIO IN YC1 and
YC2 terminal block connectors, respectively
The audio of the component video source, the “Betacam VCR”, to the
AUDIO IN COMP terminal block connector
The audio of the “DVI Graphics Source ” to the AUDIO IN DVI terminal
block connector
The audio of “VGA Graphics Source 1” and “VGA Graphics Source 2” to
the AUDIO IN VGA1 and VGA 2 terminal block connectors, respectively
3. Connect the “VIDEO OUT 1” and “VIDEO OUT 2” HD15F connectors
7
to the video acceptors, for example, a Plasma monitor and a VGA
monitor.
1 From this section on, all the information is relevant to the VP-719xl, VP-720xl, VP-723xl and VP-724xl machines, unless
noted otherwise
2 Switch OFF the power on each device before connecting it to your VP-724xl. After connecting your VP-724xl, switch on its
power and then switch on the power on each device
3 Sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb, Pr
4 Alternatively, you can connect an RGB signal (not shown in Figure 9), as follows: Red to the Y connector, Green to the
Pb/Cb connector, and Blue to the Pr/Cr connector
5 Available only on the VP-724xl, other models in this series have only one VGA graphic source
6 As required. Not all devices need to be connected
7 In the HDTV mode, the signal goes out via 3 PINS: PIN 1 is Red or Pr, PIN 2 is Green or Y, PIN 3 is Blue or Pb