Filter
Top Products
Troubleshooting
BASIC OPERATION GUIDE 6-9
MemoryCard err Press
GO
An error has occurred in writing to or reading from the Memory
Card.
• Press [Printer] and press S or T to select [GO] and press
[Enter]. The error is cleared.
—
Memory card error Insert
again.
The Memory Card has been removed during printer setup.
Insert the Memory Card.
NOTE: When inserting the Memory Card, switch off the main
power ({).
—
Insert same memory
card
The machine tried to read data from the Memory Card and did not
recognize the Memory Card.
Insert the Memory Card again.
NOTE: When inserting the Memory Card, switch off the main
power ({).
—
Format error Memory
card
The Memory Card inserted in the machine must be formatted.
Format the Memory Card.
—
Print overrun Press GO. Printing has not been performed correctly due to insufficient
memory.
• Press [Printer] to display the following messages.
- GO: Continues printing. Processed data will be output and
remaining data will be printed on the next page.
- CANCEL: Cancels printing.
- RESET: Resets the printer board. In this case, only the
printer functions will be reset.
• Press S or T to select the option required and press [Enter].
If the Auto Continue setting has been enabled, printing
automatically resumes after a preset period of time.
After this error message displays, Page Protect mode is
automatically enabled.
—
Interface occupied The selected interface is currently being used. Wait for a while
and retry.
—
Checksum Error The machine has detected an error at startup.
Switch off the main power and then switch on again. If the same
message appears, contact your Service Representative or
Authorized Service Center.
—
Message Procedure
Reference
page