Filter
Top Products
LaCie 2big Triple
User Manual
page 29
RAID
In the event that an individual hard disk fails in
the LaCie 2big, please contact your LaCie reseller or
LaCie Customer Support. Please replace a defec-
tive hard drive only with a new drive provided by
LaCie. For drive removal and replacement process,
please follow the steps below.
CAUTION: After continuous use of the LaCie 2big,
drives may be hot. Use caution when removing.
To Remove a Drive:
Turn off and unplug the LaCie 2big.
e drive tray may be locked. To unlock it, insert the
round end of the provided 2-in-1 tool into the slot
on the drive lock and turn the lock until the slot is
vertical (Fig. 3.4-A).
Draw out the drive tray by inserting your finger into
the space behind the drive tray handle and pulling to
disengage the drive (Fig. 3.4-B).
Grasp the drive tray handle and carefully extract the
drive (Fig. 3.4-C).
Turn the drive on to continue using the remaining
drive.
To Install a Drive:
Turn off and unplug the LaCie 2big.
Carefully insert the drive tray into an empty drive
bay. When the drive tray is most of the way in and
you feel resistance, press the drive tray handle firmly
until you feel the drive snap into place and the drive
tray handle is flush with the back of the 2big.
Use the 2-in-1 tool to lock the drive lock. Turn the
locks until the grooves are oriented vertically. e
drives are locked when both locks are vertical.
TeChNICAl NOTe: Data are still accessible during a
RAID 1 rebuild. e 2big can be disconnected from the
workstation during the rebuild; only the power must be
connected.
1.
2.
3.
4.
5.
1.
2.
3.
Fig. 3.4-B
Fig. 3.4-C
ImpOrTANT INfO: Drive warranty will be
void if you replace the defective drive with a drive
not provided by LaCie. Drives purchased from
LaCie are shipped pre-installed in drive trays with
handles.
Fig. 3.4-A
3.4. Removing and Installing Drives