Filter
Top Products
10
2.4 Mounting
Your LSW2F8 or LSW2F16 switch is delivered with two brackets for
mounting the switch in an EIA standard 19-inch rack. Secure the
mounting brackets onto the sides of the LSW switch, fastening them
with screws as shown in Figure 2-6.
Figure 2-6 Mounting Bracket Installation
If your site uses only a few switches and is not equipped with a
mounting rack, you may choose to place the LSW switch on a table or
wiring closet shelf. In this case, use the four self-adhesive rubber feet,
which are provided with the switch for cushioning purposes. Stick
them at the four corners of the bottom surface of the LSW switch to
cushion it against vibration.
FULL/COL
LINK/ACT
123456 78910
LSW2F8
LSW2F8_16 Guide 3/18/99 12:17 PM Page 10 (1,1)