Filter
Top Products
11
2.5 Connecting the LSW Switch
Use the following procedures to connect 10BASE-T or 100BASE-TX net-
work devices to the LSW switch:
The following table describes the two cable types:
Make sure that the length of the straight-through cable between the
switch and the other device does not exceed 100 meters, including all
patch cables and cross-connect wires.
Duplex mode: each 10/100 port (Ports 1 and 2) can detect duplex mode
automatically Ð the device being connected to must support 802.3u
autonegotiation for full duplex to be used; duplex mode for 10Mbps
ports can be selected via switches on the back of the unit.
LSW2F8 Ports 2-9 Port 1 & Port 10
LSW2F16 Ports 2-18 Normal Uplink
PC, Workstation S S C
Server S S C
Hub, Switch port C C S
Hub, Switch uplink port S S C
S = Straight Cable C = Crossover cable
Straight cable Crossover cable
Pin 1 TD+ RD+
Pin 2 TD- RD-
Pin 3 RD+ TD+
Pin 6 RD- TD-
LSW2F8_16 Guide 3/18/99 12:17 PM Page 11 (1,1)