Filter
Top Products
Chapter 3 LED Indicators
Figure 3-1 shows the LED indicators, which indicate the link status of
each of the ports, whether the LSW switch is receiving power, and the
presence of network activity and collisions on the network.
Figure 3-1 LSW2F16 Front Panel LED Indicators
3.1 Power LED
The LED on the front panel labeled PWR is used to indicate that the
switch is receiving power and is turned on. If the LED is off, check the
following to isolate the problem:
▼ Make sure the power cord is properly connected to the power outlet
and is properly inserted into the power connection on the switch
▼ Determine whether or not the outlet is functional by plugging
another device into the receptacle
▼ Turn the power switch to the ON position. If there are no problems
and the LED still does not light, contact your dealer
3.2 10/100 Mbps LEDs
Each 10/100 port (Ports 1 and 2) have the 10/100Mbps LED on the front
panel. When the LED is ON, it indicates the port is in 100Mbps mode.
Otherwise, its working in 10Mbps mode.
12
12 345678910
11 12 13 14 15 16 17 18
PORT NO.
FULL/COL
LINK/ACT
PWR
FULL/COL
LINK/ACT
PORT NO.
10/100 Mbps
LSW2F16
10/100
Full-
Duplex/Collision
Link/Activity
Full-
10/100Mbps
LSW2F8_16 Guide 3/18/99 12:17 PM Page 12 (1,1)