Lantronix XPress DR+ Network Card User Manual


 
Chapter 3: Installation and Hardware
XPress DR+ User Guide 20
Figure 3-2. Front of XPress DR+
Serial Interface
The XPress DR+ supports RS-232 via RJ45 connectors. It also supports RS-422/485 via
screw terminals (Serial Port 2 only).
Note: Serial Port 2 supports RS232, RS422, and RS485, but only one mode at a
time. This means you can use either the RJ45 connector or the terminal block,
not both.
The RJ45 serial connectors only support RS232, up to 230400 bits per second.