Filter
Top Products
Chapter 9: Setup Mode: Channel Configuration
XPress DR+ User Guide 78
Modem Mode
Command
Function
ATS0=n
Enables or disables connections from the network going to the serial
port.
n=0 disables the ability to make a connection from the network to
the serial port.
n=1-9 enables the ability to make a connection from the network to
the serial port.
n>1-9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Note: The unit recognizes these AT commands as single commands such as
ATE0 or ATV1; it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the unit's ability to send the escape sequence. The default is Y (Yes)
(send the escape sequence).
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increments the source port. The XPress DR+ increments the port number
used with each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) (000) (000) (000) _
Note: This option does not display when Hostlist is enabled from the
ConnectMode prompt (see Connect Mode on page 72 for more information).