xSenso User Guide 11
List of Tables
Table 3-4 Analog Input LEDs _______________________________________________________24
Table 3-5 Ethernet LEDs __________________________________________________________25
Table 4-4 Analog Input and Analog Output LEDs _______________________________________31
Table 4-5 Ethernet LEDs __________________________________________________________31
Table 5-4 Analog Input and Relay Output LEDs ________________________________________37
Table 5-5 Ethernet LEDs __________________________________________________________37
Table 7-3 Comparing xSenso Home Page and Device Status Page Information _______________45
Table 8-1 Network Interface Settings _________________________________________________50
Table 8-2 Network 1 (eth0) Link Settings ______________________________________________52
Table 9-2 xSenso DAQ Command ___________________________________________________53
Table 9-3 DAQ Settings ___________________________________________________________54
Table 9-4 Analog Input Settings _____________________________________________________55
Table 9-5 Analog Output Settings ___________________________________________________56
Table 9-6 Relay Output Settings ____________________________________________________57
Table 10-2 Data Chart Settings _____________________________________________________60
Table 11-4 Data Logging Settings ___________________________________________________63
Table 13-1 xSenso Alarms and Reports ______________________________________________66
Table 13-2 Control Analog Output Settings ____________________________________________66
Table 13-3 Make Connection Settings ________________________________________________67
Table 13-4 Send Email Settings _____________________________________________________68
Table 13-5 FTP Put Settings _______________________________________________________69
Table 13-6 HTTP Post Settings _____________________________________________________70
Table 13-7 Control Relay Settings ___________________________________________________70
Table 13-8 SNMP Trap Settings ____________________________________________________71
Table 14-1 Tunnel Accept Mode Settings _____________________________________________73
Table 14-2 Modbus Settings _______________________________________________________75
Table 14-3 0xxxx Read/Write Coils (Function Codes 1, 5 and 15) __________________________75
Table 14-4 3xxxx Read Only Registers (Function Codes 4 and 23) _________________________76
Table 14-5 4xxxx Read/Write Holding Registers (Function Codes 3, 16 and 23) _______________76
Table 15-1 DNS Settings __________________________________________________________77
Table 15-2 FTP Settings __________________________________________________________78
Table 15-3 Syslog Settings ________________________________________________________78
Table 15-4 HTTP Settings _________________________________________________________79
Table 15-5 HTTP Authentication Settings _____________________________________________81
Table 15-6 RSS Settings __________________________________________________________81
Table 15-7 SNMP Settings _________________________________________________________82