Filter
Top Products
Appendix A: Technical Specifications
xSenso User Guide 117
Rated current: 3A
Rated voltage: 250 VAC
Contact rating on relays:
- 30VDC 3A, 250VAC 3A, 100000 cycles (IEC 61810)
- 30VDC 3A, 240VAC 3A, 100000 cycles (UL 508)
Isolation between relay contacts and internal circuitry: 4000 VAC
Isolation between relay open contacts: 1000 VAC
UL rating: Class 2
Note: Wires attached to the relay terminal blocks must be rated 90°C or higher!
Connect Analog Inputs and Analog Outputs only to IEC Class III or NEC Class 2 Circuits.
Relay Ports are to connect only to circuit rated 100-250VAC 3A, or 30VDC 3A
Architecture
Controller: 32-bit ARM 9 microprocessor running at 400 megahertz (MHz)
Memory: 64 Mbit (8 Mbyte) Serial Flash, 512 Mbit (64 Mbyte) NAND Flash and 1 Gbit (128
Mbyte) DDR2 RAM
Terminal Block Plug Wires: 26-16 AWG
Network Interface
Interface: (1) Ethernet 10Base-T or 100Base-TX
Auto sensing for speed, duplex, and MDIX (cross-over cable)
Magnetic Isolation: 1500 VAC
Protocols: TCP, Modbus TCP, UDP, ARP, ICMP, Telnet, DHCP, BOOTP, HTTP, HTTPS,
HTTP/HTTPS POST, FTP/FTPS Put, DNS, SNTP, SMTP AUTH, SNMP (MIB II) v1/v2c/v3,
custom MIBs, AutoIP, SSH, SSL, RSS, XML, FTP, Syslog, uPnP (device discovery)
Note: See Protocol Support (on page 17) for updated protocols supported.
Management
(1) USB port
Web Configuration (HTTP/HTTPS)
XML
CLI (Telnet/SSH)
DeviceInstaller - Windows based utility for device discovery and system recovery
Security
Username/Password Authentication
128, 192, 256-bit AES Encryption
SSL, SSH