Filter
Top Products
10 - PC400 Terminal Installation & User’s Guide
PC400TX TCP/IP Connections (optional)
For Ethernet communications, CAT 4 or 5 unshielded twisted pair high-speed data
communication cable is recommended. A standard Ethernet cable should be used, unlock
and remove the terminal from the mounting bracket. Route the cable through the desired
knockout of the mounting plate and plug the RJ45 plug into the Ethernet Communication
port as shown below
See Appendix D for the directions on installing a 10Base T module in the field.
To make a TCP/IP connection
♦ Connect a standard Ethernet cable to the network switch.
♦ Insert the other end of the standard Ethernet cable through a knockout in the terminal
back box and plug it into the clock’s Modem/10 Base T connection port as shown in
the diagram below, Figure 5.
Modem /
10 Base T
Connection
Port
Figure 5