Filter
Top Products
12 - PC400 Terminal Installation & User’s Guide
CHAPTER 4
Setup the Clock
You must power up and configure each clock when you install it. You can do this
through the terminal setup mode. Note: The set up of the PC400 and PC400TX are the
same.
Starting the Terminal Setup Mode
The terminal must first go through its power - up test before you can start the setup
mode. After the power - up test completes the terminal will display “All Systems OK”.
To power up the clock
♦ With the terminal’s 9VAC power supply plugged into an electrical outlet, plug the
other end into the terminals power connector; see the diagram below, Figure 7.
♦ The terminal goes through the power up test, beeps and the lights flash.
Power Connector
Figure 7