Filter
Top Products
Table 2. ThinkServer EasyStartup DVD (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem
is resolved.
• See the Chapter 7 “Parts Listing, TS200v Machine Types 0981, 0992, 1008, and 1010” on page 59
to
determine which components are customer replaceable units (CRUs) and which components are eld
replaceable units (FRUs).
Symptom
Action
The EasyStartup
program will not start
the operating-system
medium.
Make sure that the operating-system medium is supported by the
EasyStartup program.
See the EasyStartup User Guide for a list of supported operating-system versions. The
EasyStartup User Guide and compatibility notes are available through the EasyStartup
program.
Miscellaneous error messages
Message/Symptom FRU/Action
Changing display colors Display/Monitor
Computer will not power-off. See “Hard disk drive boot
error” on page 16.
1. Power Switch
2. System Board
3. Riser card, if installed.
Computer will not RPL from server
1. Ensure that network is in startup sequence as rst
device or rst device after diskette.
2. Ensure that network adapter is enabled for RPL.
3. Network adapter (Advise network administrator of
new MAC address)
Computer will not perform a Wake On LAN® (if applicable) 1. Check power supply and signal cable connections
to network adapter.
2. Ensure that the operating system settings are set to
enable Wake on LAN.
3. Ensure Wake On LAN feature is enabled in
Setup/Conguration (see “Starting the Setup Utility
program” on page 77)
4. Ensure network administrator is using correct MAC
address.
5. Ensure no interrupt or I/O address conicts.
6. Network adapter (advise network administrator of
new MAC address)
Dead computer. See “Hard disk drive boot error” on page
16.
1. Power Supply
2. System Board
Diskette drive in-use light remains on or does not light
when drive is active.
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
Blank screen except for ashing cursor.
1. System Board
2. Primary Hard Disk Drive
3. Hard Disk Drive Cable
Incorrect memory size during POST
1. Run the Memory tests.
2. Memory Module
3. System Board
Chapter 4. Diagnostics 19