Filter
Top Products
Figure 5. Removing the server cover
Removing and reinstalling the front bezel
Attention
Do not open your server or attempt any repair before reading and understanding the Chapter 1 “About this
manual” on page 1
and the Safety Information book. To obtain a copy of the Safety Information book,
go to:http://www.lenovo.com/support
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 30.
3. Remove the front bezel by releasing the three plastic tabs on the left side and pivoting the front bezel
outward.
Chapter 6. Replacing FRUs 31