Filter
Top Products
• If you are using the BitLocker
®
drive encryption, you should not change the startup sequence. BitLocker
drive encryption detects the change of startup sequence and locks the tablet from booting.
Changing the startup sequence
To change the startup sequence, do the following:
1. Tap Boot. The default boot list is displayed, showing the order in which devices will be started up, even
devices that are not attached to or installed on your tablet are listed.
2. In the Boot submenu, tap the menu item to specify the startup sequence that runs when you turn on
the power.
3. Save the changes and restart the system.
The following table lists the Startup menu items.
Notes:
• Default values are in boldface.
• In each submenu, tap the default value to show selectable options and select a desired option.
• Some items are displayed on the menu only if the tablet supports the corresponding features.
Table 3. Startup menu items
Menu item Value
Comments
Boot
See “Changing the startup sequence” on
page 48
.
Network Boot
Select the boot device when the system
wakes from LAN. If Wake On LAN is
enabled, the network administrator can
turn on all of the computers in a LAN
remotely by use of network management
software.
UEFI/Legacy Boot
• Both
– UEFI/Legacy Boot Priority
– UEFI rst
– Legacy rst
• UEFI Only
• Legacy Only
CSM Support (for UEFI Only)
• Yes
• No
Select system boot capability.
• Both: Select priority of boot options
between UEFI and Legacy.
• UEFI Only: The system will boot from
the UEFI enabled operating system.
• Legacy Only: The system will boot
from any operating system other than
the UEFI enabled one.
Note: If you select UEFI Only, the
system cannot boot from the bootable
devices that do not have the UEFI
enabled operating system.
Compatibility Support Module (CSM) is
required for booting the legacy operating
system. If you select UEFI Only, CSM
Support is selectable. For Both or
Legacy Only mode, CSM Support is not
selectable.
48 User Guide