Filter
Top Products
Diagnostic Error Code FRU/Action
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
1. IDE signal cable
2. Check power supply.
3. Reseat IDE signal cable.
4. IDE device
5. System board
025-195-XXX IDE interface Test aborted by user Information only Restart the test, if necessary.
025-196-XXX IDE interface test halt, error threshold
exceeded
1. Press F3 to review the log le.
2. Restart the test to reset the log le.
025-197-XXX IDE interface test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 37
.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
025-198-XXX IDE interface test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 37
.
2. Flash the system and re-test. See “Updating
(ashing) the BIOS” on page 157
.
3. Go to “Undetermined problems” on page 65.
025-199-XXX IDE interface test failed, cause unknown
1. Go to “Undetermined problems” on page 65.
2. Flash the system and re-test. See “Updating
(ashing) the BIOS” on page 157.
3. Replace component under function test.
030-000-XXX SCSI interface Test Passed
No action
030-00X-XXX 030-01X-XXX SCSI interface failure 1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
030-027-XXX SCSI interface Conguration/Setup error 1. SCSI signal cable
2. Flash the system. See “Updating (ashing) the
BIOS” on page 157.
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
030-03X-XXX 030-04X-XXX SCSI interface error 1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
030-195-XXX SCSI interface Test aborted by user
Information only Restart the test, if necessary.
54 ThinkStation Hardware Maintenance Manual