Filter
Top Products
Figure16. Connecting the cable and installing the screw
9. Go to “Completing the parts replacement” on page 96.
Removing and reinstalling the system board shield
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove and reinstall the system board shield.
To remove and reinstall the system board shield, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other at surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 71.
4. Remove the VESA mount bracket. See “Removing and reinstalling the VESA mount bracket” on page 71.
5. Locate the system board shield in the computer. See “Locating major FRUs and CRUs” on page 63.
76 Lenovo S710 All-In-OneHardware Maintenance Manual