Filter
Top Products
Installation
required. Just connect any LAN port to a normal port on the other hub, using a standard
LAN cable.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne Broadband VPN
Gateway. Use the cable supplied with your DSL/Cable modem. If no cable was supplied,
use a standard cable.
4. Power Up
• Power on the Cable or DSL modem.
• Connect the supplied power adapter to the LevelOne Broadband VPN Gateway and power
up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
• The Power LED should be ON.
• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
• For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
• The WAN LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
7