Filter
Top Products
VPN
• Click "Next" to view the final screen.
• On the final screen, click "Finish" to save your settings, then "Close" to exit the Wizard.
IKE Phase 1
If you selected IKE, the following screen is displayed after the Traffic Selector screen.
Figure 52: VPN Wizard - IKE Phase 1
IKE Phase 1 (IKE SA)
Direction
Select the desired option:
• Initiator - Only outgoing connections will be created. Incoming
connection attempts will be rejected.
• Responder - Only incoming connections will be accepted.
Outgoing traffic which would otherwise result in a connection
will be ignored.
• Both Directions - Both incoming and outgoing connections are
allowed.
Local Identity
This setting must match the "Remote Identity" on the remote VPN.
IP address is the more common method.
Remote Identity
This setting must match the "Local Identity" on the remote VPN.
IP address is the more common method.
Authentication
• RSA Signature requires that both VPN endpoints have valid
Certificates issued by a CA (Certification Authority).
• For Pre-shared key, enter the same key value in both endpoints.
The key should be at least 8 characters (maximum is 128 charac-
ters). Note that this key is used for the IKE SA only. The keys
used for the IPsec SA are automatically generated.
Encryption
Select the desired method, and ensure the remote VPN endpoint uses
the same method. The "3DES" algorithm provides greater security
than "DES", but is slower.
77