Filter
Top Products
- 14 -
To install GNS-8000B in office network, please follow the steps: a, b, c, d, e
below.
#
To use fail over or load balance function, please connect both LAN 1 and LAN
2 to switch/ hub/ router. For further details, please refer to Chapter
6.5.1.
* Optional step. You can skip this step if you are not using CD/DVD
backup/restore or tape backup service.
Note: To connect GNS-8000B to a PC, please use a network cable to
connect the PC to LAN 1 or LAN 2 of GNS-8000B. For further details
about accessing GNS-8000B, please refer to Chapter 6.
d. Connect the power
cord and plug in the
other end of the cord
to power outlet.
e. Turn on the
server.
a. Connect Gigabit port LAN 1 or
LAN 2
#
to a switch/ hub/
router by a network cable.
b. Connect CD/DVD
burner *.
c. Connect tape drive
to the SCSI connector
for tape back up
service*.