LevelOne WAB-1000 Network Router User Manual


 
10
Installation Instructions
The WAB-1000 intended to be installed as part of a complete wireless design solution.
This manual deals only and specifically with the single WAB-1000 device as a unit. The
purpose of this chapter is the description of the device and its identifiable parts so that the user is
sufficiently familiar to interact with the physical unit. Preliminary setup information provided
below is intended for information and instruction of the wireless LAN system administration
personnel.
It is intended, and is the philosophy of the manufacturer, that the user not be required to
open the individual unit. Any maintenance required is limited to the external enclosure surface,
cable connections and to the management software (as described in Chapter three and four) only.
A failed unit should be returned to the manufacturer for maintenance. Sites requiring emergency
backup should maintain extra units of the device to interchange in case of failure.
Minimum system and component requirements
The WAB-1000 is designed to be attached to the wall at appropriate locations. To complete
the configuration, you should have at least the following components:
PCs with one of the following operating systems installed: Windows NT 4.0, Windows
2000 or Windows XP;
A compatible 802.11b/g PC Card or 802.11b/g device for each computer that you wish to
wirelessly connect to your wireless network;
Access to at least one laptop or PC with an Ethernet card and cable that can be used to
complete the initial configuration of the unit;
A Web browser program (such as Microsoft Internet Explorer 5.5 or later, or Netscape
6.2 or later) installed on the PC or laptop you will be using to configure the Access Point;
and
TCP/IP Protocol (usually comes installed on any Windows PC.)
Ensure the cabling is correctly installed
The WAB-1000 is well protected in a metal enclosure which is generally bolted to a surface.
The device should not be opened.
The following illustration shows the external cable connectors on the WAB-1000.