LevelOne WBR-3407 Network Router User Manual


 
Installation
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the WBR-3407.
Both 10BaseT and 100BaseT connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN
cable. Any LAN port on the WBR-3407 will automatically function as an "Uplink" port
when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the WBR-3407 (the RJ11
connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the WBR-3407 and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
The Power LED should be ON.
The Status LED should flash, then turn Off. If it stays on or blinking after 60 seconds,
there is a hardware error.
For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is
also ON.)
The WLAN LED should be ON
The WAN LED should be ON if ADSL line is connected.
For more information, refer to Front-mounted LEDs in Chapter 1.
7