Lexmark 031 Printer User Manual


 
Replace wiper
Replace the fuser wiper, or try one or more of the following:
Touch Continue to clear the message and continue printing.
Touch Ignore to clear the message, but at the next power-on, the message appears again.
Restore Held Jobs?
Try one or more of the following:
Touch Continue to restore all held jobs stored on the printer hard disk.
Touch Do not restore if you do not want any print jobs to be restored.
Scan Document Too Long
The scan job exceeds the maximum number of pages. Touch Cancel Job to clear the message.
Scanner ADF Cover Open
The ADF cover is open. The message clears when the cover is closed.
Scanner Jam Access Cover Open
Close the bottom ADF door to clear the message.
Securely clearing disk space
The printer hard disk wiping process needs to recover. The message clears when all blocks are cleared.
Sending page <n>
The printer sends page <n> of the fax job, where <n> is the number of the page sent. Wait for the message to clear.
Serial <x>
The printer is using a serial cable connection. The serial port is the active communication link.
Set clock
The clock is not set. This message appears if no other fax status message appears. It remains until the clock is set.
SMTP server not set up. Contact system administrator.
An error occurred on the SMTP server, or the SMTP server is not configured properly. Touch Continue to clear the
message. If the message appears again, contact your system support person.
Understanding printer messages 231