Filter
Top Products
4-16 Service Manual
4227-X00
Carrier Plate Removal
1. Remove the top cover.
See “Top Cover Removal” on page 4-6.
2. Remove the print unit.
3. Remove the carrier.
4. Remove the lower pinch roller.
5. Remove the carrier motor.
6. Remove the auto gap motor and its bracket.
7. Remove the carrier motor bracket.
8. Remove the right side frame.
9. Remove the two screws holding the carrier plate to the left side
frame, and remove the carrier plate.
Label Jam Removal
When a pressure-sensitive label separates from its protective
backing and jams and sticks to the paper separator below the carrier
plate, the following procedure should be used to remove the label.
1. Remove the top cover.
See “Upper Feed Roller Removal” on page 4-39.
2. Remove the tractor assembly.
3. Remove the print unit.
See “Print Unit Removal” on page 4-30.
4. Remove the paper separator.
See “Paper Separator Removal” on page 4-28.
5. Carefully remove the label from the paper separator. If the label
is jammed below the carrier plate or on the lower portion of the
paper guide/platen assembly, carefully remove the label without
scratching either surface.