Filter
Top Products
4026-0XX
Diagnostic Information 2-35
Wrinkled Paper/Envelope/Transparency
Paper Never Leaves The Tray or Fails To Reach The Input Sensor
Note: Remove the Optional Second Paper Tray if installed before
performing the following checks.
FRU Action
1
Paper Check thepaper supply for wrinkled or damaged
paper, out of specification paper, envelopes or
transparency material. Correct as necessary.
2
Paper Path Check the paper feed lift plate assembly, input
sensor actuator, paper separators, paper feed
rollers or anything in the paper path that might
catch the paper or cause the paper to wrinkle.
FRU Action
1
Paper Check the paper supply for any paper, envelope,
transparency, label, or index cards that may be
causing a problem.
2
Paper Take-
Up Solenoid
Be sure the paper take-up solenoid is picking. If
incorrect go to the “Paper Take-Up Solenoid
ServiceCheck”onpage2-32.
3
Paper Frame
Assembly
Check the paper feed frame assembly for proper
operation. If incorrect go to the “Paper Feed
Frame Assembly Service Check” on page 2-37.
4
D-Roll
Assembly
Check the D-Roll assembly for proper operation.
If incorrect go to the “D-Roll Assembly Service
Check” on page 2-16
5
Paper Lift
Plate Assem-
bly
Check the paper lift plate assembly for proper
operation. If incorrect, replace the paper lift plate
assembly.
6
Print Media
Selection
Lever
(Models 06C
and 06F)
Check the print media selection lever on models
06C and 06F for the correct setting. This is
determined by the media being used ( labels,
card stock, paper, etc. ).