Filter
Top Products
4026-0XX
2-36
Paper Never Reaches The Exit Sensor
Paper Jam In The Fuser Assembly
Any Jam After The Exit Sensor
FRU Action
1
Input Sensor Check the input sensor for proper operation. If
incorrect, go to the “Input Sensor Service
Check” on page 2-20.
2
D-Roll
Assembly
Check the D-Roll assembly for proper operation.
If incorrect go to the “D-Roll Assembly Service
Check” on page 2-16.
3
Paper Feed
Frame
Assembly
Check the paper feed frame assembly. If paper
is not being fed to the fuser assembly, go to the
“Paper Feed Frame Assembly Service Check”
on page 2-37.
4
Fuser Assem-
bly
Be sure the fuser assembly is free of excessive
toner or other contamination and is operating
correctly. Repair as necessary.
FRU Action
1
Fuser Assem-
bly
Check the fuser assembly for excessive toner
build-up on the input paper guide, paper separa-
tors, hot roll, backup roll and any signs of dam-
age, overheating, or broken and damaged parts.
Repair as necessary.
2
Exit Sensor Go to the “Exit Sensor Service Check” on
page 2-17.
FRU Action
1
Fuser Assem-
bly
Manually turn the fuser drive gear and be sure
the fuser drive assembly is working correctly. Be
sure the paper feed exit shaft and gear are also
operating properly. Repair as necessary.
2
Exit Sensor Go to the “Exit Sensor Service Check” on
page 2-17.