Filter
Top Products
English Manual 12
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (DEC 2001)
F6 SET
Configures the OSD settings of the console used. The following sub menus will be listed:
Setting Function
OSD ACTIVATING
HOTKEY
Can be selected for either pressing CONTROL key or SCROLL key
twice
CHANNEL
DISPLAY MODE
Selects the options how the channel display of the active port shows up
on the monitor:
- Port number + name
- Port number only
- Name only
CHANNEL
DISPLAY
DURATION
Selects how long the channel display is shown on the monitor:
- USER DEFINED: selectable 1-255 seconds
- ALWAYS ON
CHANNEL
DISPLAY
POSITION
Select the position of the channel display on the monitor. Move the
position with cursor keys and confirm by pressing ENTER.
SCAN MODE Selects which ports are available for auto scan mode. (Only accessible
ports – see F5 – are available for auto scan.)
The following selections are possible:
- ALL: all ports that are accessible according to F5 ACCESSIBLE
QVIEW: all ports marked QV in the OSD list
- POWERED ON: all ports powered on
- POWERED ON + QVIEW: all ports powered on and marked QV
- QVIEW + NAME: all ports marked QV that have been named
- NAME: all ports that have been named
SCAN DURATION Selects the dwell time per port in auto scan, selectable 1-255 seconds.
PRIVATE MODE
ENABLE: This port / computer can be accessed from this console only
after being selected.
DISABLE: This port is available to all consoles.
The selection is made by pressing the ENTER key.
RESTORE
DEFAULT VALUES
This function is used to undo all User changes and return the setup
to the original factory default settings - except for the Names that
were assigned to Ports, which are retained.
MOUSE BUTTON
SETUP
This function allows you to set the mouse for right or left handed
operation. Use [Enter] to toggle between the two.
SET PASSWORD
This function is for Users to set their passwords:
1. When you access this function, if you already have a password
you must enter it in order to continue.
2. A screen appears that allows you to key in your new password.
The password maybe up to 8 characters long, and can
consist of any combination of letters and numbers (A - Z, 0 - 9).
3. To modify or delete a previous password, use [Backspace] to
delete the characters.
4. Key in the password, then press [Enter]. You are asked to key the
password in again, in order to confirm that it is correct. Key in the new
password again, and then press [Enter]. If the two entries match, the
new password is accepted. If the entries do not match, you must start
again from the beginning.