Filter
Top Products
EN 11
After selecting IP Configuration key in the IP Address of the USB 2.0 DEVICE SERVER box in the IP
Address field followed by proper Subnet Mask & Gate Way as shown below.
After entering IP address, Subnet Mask & Gate Way then click on “save” button. Then USBIP Admin
shows a progress bar, after the process is finished, the following message box will be displayed.
Note: Every unit in the network is identified by its IP address. The utility treats each IP address as unique
device. If the IP address of the box is modified, the software treats the same box as a different device and
will open a Found New Hardware Wizard.
Continue the Found New Hardware Wizard to install the Virtual USB-over-IP bus driver.
Now USB 2.0 DEVICE SERVER box appears with changed IP Address under USBIP Admin utility.
Password:
The Password Settings page allows you to change or Enable/Disable password of the USB 2.0 DEVICE
SERVER box. The Password settings page will be as shown below.
Check the Modify box to Enable or Disable password option to USB 2.0 DEVICE SERVER box.