Filter
Top Products
Working It Connecting External Speakers
2• 9
Connecting External Speakers
The following pages illustrate how to connect your Duoverb to Line 6 speaker cabinets.
If you are using any other cabinets be sure to check your speaker cabinets’ impedance
and choose the matching setting on your Duoverb’s rear panel impedance switch. In
correct settings will give you less volume than you’d expect, or cause Duoverb to
shutdown its power amps after a while to protect them from overheating—if you are
uncertain about the settings to use with your setup, please consult an expert.
Hooking up your Combo in stereo to a single Duoverb 2x12 Cabinet
Hooking up your HD in stereo to a single closed back 2x12 cabinet
LEFTRIGHT
STEREO - 8
USE BOTH JACKS
80 WATTS MAX PER SPEAKER
MONO - 4
THIS JACK ONLY
160 WATTS TOTAL MONO
N222
Connect the speakers
from your combo to
the right outputs.
RIGHT LEFTRIGHT
SPEAKER OUTS / CLASS 2 WIRING
LEFT- MONO -
OUTPUT
IMPEDANCE
4 OHMS
CABINET
MODELING
OPEN8 OHMS CLOSEDOFF
*If you are using an open
back cabinet such as the
Duoverb Extension
Cabinet select OPEN
CABINET MODELING.
LEFTRIGHT
STEREO - 8
USE BOTH JACKS
80 WATTS MAX PER SPEAKER
MONO - 4
THIS JACK ONLY
160 WATTS TOTAL MONO
N222
*
OUTPUT
IMPEDANCE
4 OHMS
CABINET
MODELING
OPEN8 OHMS CLOSEDOFF
RIGHT LEFTRIGHT
SPEAKER OUTS / CLASS 2 WIRING
LEFT
- MONO -
Duet Manual Page 9 Tuesday, October 1, 2002 9:36 PM