Filter
Top Products
40
Linksys Instant EtherFast
®
Series
39
EtherFast
®
10/100 LAN Cards
12. When you reach the following screen, choose either Workgroup or
Domain, depending on the type of network you're setting up. (Your
Microsoft documentation explains the difference between Workgroups and
Domains.) Click the Next button to continue.
13. On the next screen, click the Finish to complete installation. When asked
if you want to restart your computer, remove the Driver Disk and click the
Ye s button.
14. Once your PC has rebooted and you are logged in, double-click the
Network Neighborhood icon on your desktop. Make sure that you have
access to the network. If you do, your card has been properly installed.
The Windows NT Installation and Setup of the EtherFast
®
10/100 LAN
Card is complete. Do not continue on with the next set of instructions.
They are for NT users who already had their networking configured.
NNoottee
: If you had previously installed any NT service packs,
you must re-install them. Otherwise, you may receive Not
Enough Service Storage Space errors in the Event Viewer.
NNoottee::
If you need to install the TCP/IP Protocol, consult your
Windows NT documentation. Linksys does not provide tech-
nical support for TCP/IP configuration or troubleshooting.
10. NT will ask you to choose a media type for the EtherFast card. Choose
AutoSense. You can change these settings later if needed. Then, click the
Continue button.
11. You may be asked if there if a DHCP Server on your network. Verify if
there is, and if you wish to use DHCP, and click the Yes or No button on the
following screen, accordingly.
11. NT will copy the necessary network drivers to your PC. When the copying
is complete, you will see a list of installed bindings. These binding are
appropriate to the card you are installing. Click the Next button to go
through these two screens..
NNoottee::
For information and help on bind-
ings, services and protocols, check
your Windows NT documentation.