Filter
Top Products
44
Linksys Instant EtherFast
®
Series
43
EtherFast
®
10/100 LAN Cards
10. Remove your Driver Disk and CD-ROM and click the Ye s button to restart
your PC.
11. Once your PC has rebooted, double-click the Network Neighborhood icon
on your desktop. Make sure that you have access to the network. If you do,
your card has been properly installed.
• If you had previously installed any NT service packs, you must re-install
them. Otherwise, you may receive Not Enough Service Storage Space
errors in the Event Viewer.
• If you need to install the TCP/IP protocol, refer to your Windows NT doc-
umentation. Linksys does not provide technical support for the configura-
tion or troubleshooting of the TCP/IP protocol
The Windows NT Installation and Setup of the EtherFast
®
10/100 LAN Card is complete.
NNoottee::
If you need to install the TCP/IP Protocol, consult your
Windows NT documentation. Linksys does not provide tech-
nical support for TCP/IP configuration or troubleshooting.
NNoottee
: If you had previously installed any NT service packs,
you must re-install them. Otherwise, you may receive Not
Enough Service Storage Space errors in the Event Viewer.
5. Highlight the Linksys LNE100TX(v5) Fast Ethernet Adapter entry in the
window that appears. Then, click the OK button.
6. When NT asks you for the media type. Choose the AutoSense option. When
finished, click the Continue button. Then, click the Close button.
7. If Windows NT asks you to supply your original Windows NT CD-ROM or
setup disks, direct Windows NT to the proper location (most likely D:\i386,
where D represents the letter of your CD-ROM drive).