Filter
Top Products
EtherFast
®
Cable/DSL Routers
27
Instant Broadband
™
Series
9. When your PC has finished restarting, click the Start button, and select
Settings and Control Panel. Double-click Network. Make sure that
TCP/IP is installed on your PC, as shown on the screen in Figure 6-8. By
default, Windows 98 has TCP/IP installed. If TCP/IP is not installed, please
go to “Appendix D: Installing the TCP/IP Protocol” for installation instruc-
tions.
Your USB driver installation is now complete.
Go to “Chapter 7: Configure the PCs.”
26
1. With the Router powered up and connected to your PC’s USB port using a
USB cable, start up your PC in Windows 2000, and have the Router’s driver
disk available. Windows will notify you that the PC has found new hardware.
The Windows’ Hardware Wizard will then notify you that it is ready to start
installing the driver files on your PC, as shown in Figure 6-9. Click the Next
button.
2. Select Search for a suitable driver for my device (Recommended), as
shown in Figure 6-10, and click the Next button.
Installing the Windows 2000 Driver
Figure 6-9
Figure 6-10
Figure 6-8