Filter
Top Products
EtherFast
®
Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch
Modify Subnet
The Modify Subnet screen allows you to modify an IP interface.
• VLAN - The VLAN associated with this IP interface.
• Select - Use this option to create or modify a VLAN.
• IP Address - The IP address associated with the specified VLAN
interface.
• Subnet Mask - A template that identifies the address bits in the
host address used for routing to specific subnets.
• Proxy ARP - Enable or disable the Proxy Address Resolution
Protocol.
• RIP - Enable or disable the Routing Information Protocol for
unicast routing. Select Advanced to make more changes.
• OSPF - Enable or disable the Open Shortest Path First protocol.
Select Advanced to make more changes.
• DVMRP - Enable or disable the Distance-Vector Multicast Routing
Protocol. Select Advanced to make more changes.
Select Delete to delete a subnet. Select Apply to make changes. Select OK to
return to the previous panel. Select Cancel to cancel any changes.
51
Instant EtherFast
®
Series
50
Subnet Configuration
The Subnet Configuration screen allows you to specify an IP interface for
any VLAN configured on this Switch that needs to communicate with a
device outside of its own group (that is, another network segment).
•IP Address - The IP address associated with the specified VLAN interface.
By convention, the last three digits should be set to “254” to readily distin-
guish this device as a router port. To modify this IP interface, select it and
press Enter.
•Subnet Mask - A template that identifies the address bits in the host
address used for routing to specific subnets. Each bit that corresponds
to a “1” is part of the network/subnet number, and each bit that
corresponds to “0” is part of the host number.
•VLAN - The VLAN associated with this IP interface.
•RIP - Routing Information Protocol for unicast routing.
•OSPF - Open Shortest Path First routing protocol.
•DVMRP - Distance-Vector Multicast Routing Protocol.
•Status - Status of the VLAN IP.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes. Select Prev Page to view the previous
page. Select Next Page to view the next page. To display a specific page, set
the page number in the Page field and then press Apply. Select Add to add an
IP interface.