EtherFast Cable/DSL Routers
100 Orange. The 100 LED lights up when a
successful 100Mbps connection is made
through the corresponding port. If this
LED does not light up, then your connec-
tion speed is 10 Mbps.
USB The USB LED lights up when the USB
port is successfully connected to a PC,
USB hub, or other USB device.
The WAN Indicators
Link Green. The Link LED lights up when a successful connec-
tion is made between the Router and your broadband device
or network.
Act Green. The Act LED flickers when the Router is sending or
receiving data over the broadband WA N port.
Diag Orange. The Diag LED lights up when the Router goes
through its self-diagnostic test during boot-up. It will turn
off upon successful completion of the diagnosis. This LED
will also light up when you make changes in the Utility and
click Apply to save them.
If this LED stays on for an abnormally long period of time,
see the Troubleshooting section.
14
Instant Broadband Series
Buttons
The Reset Button Details on the Reset button are found on page 7.
The 3-Port Router’s Front Panel LEDs
The LAN Indicators
Power Green. The Power LED lights up green when the
Router is powered on.
Link/Act Green. The Link/Act LED serves two purposes. If
the LED is continuously lit up, the Router is suc-
cessfully connected to a device through the corre-
sponding RJ-45 port (1, 2, or 3). If the LED flick-
ers, then that port is sending or receiving data to
and from the network.
Full/Col Green. The Full/Col LED also serves two purpos-
es. If this LED is continuously lit up, the connec-
tion made through the corresponding port is suc-
cessfully running in Full Duplex mode. If the
LED is flickering, the connection is experiencing
collisions. Infrequent collisions are normal.
If this LED flickers too often, there may be a
problem with your connection. See the
Troubleshooting section if you have problems.
13