Linksys WRE54G Network Card User Manual


 
10
Chapter 5: Setting Up the Wireless-G Range Expander
Wireless-G Range Expander
3. The next screen advises you to have your PC communicating with your wireless network before starting the
setup process. The Range Expander does not yet require connection. You should always connect your
networking gear to a surge protector. Click the Next button to continue or Exit to exit the Setup Wizard.
4. The Setup Wizard will run a search for your wireless network. If found, you will be asked to
confirm the settings. If you confirm them,
proceed to Step 5. If you’d like to chose a different
access point for the Range Expander to communicate with,
continue to Step 4b below. If no
wireless network is found,
click Continue and a list with the status information for each access
point will be displayed.
a.A screen will notify you when no access point is detected on your network. Click
Continue to survey your network for any access points or wireless routers or Cancel to
exit the Setup Wizard.
b.The site survey results will display all available access points and wireless routers in your network.
Select the one to which you wish to connect from the list shown. Then, click Yes to continue or No to
return to the beginning of the Setup Wizard.
Figure 5-3: Confirm
Wireless Settings
Figure 5-2: Connecting to an access point
Figure 5-5: Choose an access point
Figure 5-4: Cannot find
Wireless Network