Filter
Top Products
23
Changing the System Manager’s Password
This section tells you how to change the System Manager’s password (for
mailbox 0) that is required for changing PARTNER Voice Messaging settings.
The factory setting for mailbox 0 is 1234. To prevent unauthorized
programming of the system, you should change the default password
immediately after installation or any time the password has been reset. You
must assign four digits for a password. It is recommended that you create a
password from random, nonsequential digits.
You cannot reinitialize the System Manager’s password.
If you change the
password and forget it, you can contact the National Customer Care Center at
1 800 628-2888 or call your Lucent Technologies Representative or local
Authorized Dealer for instructions for how to reset the password.
To change the password for mailbox 0:
1. If necessary, access the Programming Main Menu. If you are already at
the Programming Main Menu, skip to Step 2.
A) Call PARTNER Voice Messaging:
■ If calling internally, press i777 or the programmed
VMMsgs button.
■ If calling from outside the system, press *Q (*7) during the
general mailbox greeting.
B) Enter
0 followed by the password for mailbox 0.
Press
5
to change the password.
The prompt asks you to enter your new password.
2. Enter four digits for the new password.
The prompt asks you to re-enter your new password.
3. Re-enter your new password.
The new password is now active.
4. Press *Q (*7) to return to the Programming Main Menu or press
**9 to exit programming, or hang up.