Filter
Top Products
MAGMA
Chapter 2 Installation Guide 5
the card into any available PCI slot and securing it with a retaining
screw.
Step Two: Attach PCI Expansion and Power Cable(s)
A set of four 3-meter shielded, high-speed cables are included with your
PCI Expansion System. One end of each cable should be connected to
the RJ45 connectors on the 64-bit Host Interface and the other end
should be connected to the correct RJ45 connector on the rear of the
expansion system by following the diagrams shown below:
PCI Expansion Cable Connection Diagram
PCI Host Interface
Expansion System
L0 L0
Rx0 Rx0
Tx0 Tx0
L1 L1
Rx0 Rx0
Tx0 Tx0
CAUTION
All cables attached to the expansion system must be securely
fastened. If not fastened tightly, the connectors may cause intermitten
t
or lost connections.
Check that the expansion system On/Off switch is set to the OFF
position.
Connect the power cord to the power-in receptacle located at the rear of
the enclosure. If your expansion system includes a 300W redundant
power supply, make sure you attach a power cord to each power supply
module and set the power supply switch to the ON position.