Filter
Top Products
SETTING UP
ENGLISH
8
Connecting Digital Components
The following illustrations show you how to connect
digital audio components.
To output digital audio signals to another audio
component
Connect the DIGITAL OUT (RCA) jack on the PMD690 to
the digital input jack on the destination component. Turn
the output on by placing the switch (next to the output
jack) in the ON position.
Notes
• Digital audio is only output during normal playback and EDL
playback. Digital audio is not output during recording even if
the output is turned on.
• When the digital output is not used, make sure to keep the
DIGITAL OUT switch OFF to save battery life.
• Make sure the destination component accepts the SPDIF (or
IEC-958-II) type digital audio format.
• Make sure the destination component accepts a sampling
frequency of 48kHz or contains a digital sample rate converter.
Other Connections
Headphones
Connect headphones to the HEADPHONE output as
indicated below. Both recording and playback can be
monitored through connected headphones.
Notes
• Use the HP/SPK VOLUME knob to control the volume of the
headphone.
• The sound from the internal speaker is muted automatically
when headphones are connected.
Open Close
Recording Pause recording Resume recording
Playback Resume playback Pause playback
Polarity of the REMOTE jack
Remote Control
Available Functions
The remote Pauses or Un-Pauses the unit during playback
and recording.
DAT, etc.
DIGITAL IN
REMOTE
2.5 mm Jack
Contact closure
switch