Filter
Top Products
THE EDL
ENGLISH
23
Editing EDL Marks
After all the EDL marks are placed in the audio tracks of a
card, they can be edited by changing the mark types,
erasing specific marks, or erasing all the marks.
Changing a Mark Type
Locate the EDL mark to be changed by using the mark
search functions. When the desired EDL mark is located,
press the MARK SELECT button to display the current
mark type. Each subsequent press of the MARK SELECT
button will then change the mark type in the following
order.
Notes
• The mark type can also be automatically saved by searching
for the next or previous mark on the card.
• There can be only one A and one B point on each card. If an A
or B point exists on a card and a new A or B point is marked,
the new A or B point replaces the old A or B point and the old
A or B point becomes a P point.
Erasing an EDL Mark
Locate the EDL mark to be erased by using the mark
search functions. When the desired EDL mark is located,
press the ERASE button so that the display flashes the
mark type of the selected mark followed by the "Erase"
message. Press the ERASE button again to confirm the
Erase function (or press the STOP button to cancel). When
the erase operation is complete, the "done" message will
be displayed and then the unit will return to the point
where the mark was in the pause mode.
The complete procedure is displayed as follows.
RENUMBER ERASE SILENT SKIP AUTO MARK
FORMAT PRESET
REPEAT
OVER
-dB
50 40 24 6 2 0
TRACK
12
OVER
5
5
5
5
5
5
5
5
5
5
5
5
5
5
5
5
Waiting for confirmation.
Press the ERASE button to confirm.
Press the STOP button to cancel.
Erase operation executing.
Erase complete.
The PMD690 returns to the location of the erased mark.
Note
• Erasing an EDL mark will automatically renumber all the EDL
marks on the card. The result is similar to the track renumber
function that is described on page 19 in the Track Editing section.
-dB
50 40 24 6 2 0
12
OVER
-dB
50 40 24 6 2 0
12
OVER
-dB
50 40 24 6 2 0
12
OVER
-dB
50 40 24 6 2 0
12
OVER
P : Play
S : Skip
-a : Repeat Point A
-b : Repeat Point B
When the desired mark type is displayed, press the
PLAY/PAUSE button to save the mark type. If you
decide not to change the mark, press the STOP button to
cancel the mark changing operation.