Filter
Top Products
FPM100 User’s Manual
Figure 6 – NMEA 2000
®
Connector Face Views
2.5.2 Pressure Transducer Connections
The FPM100 pressure transducer connections are made by connecting to the 12-pin terminal
strip on the top of the unit. First, remove the four screws at the corners of the unit detaching
the splash guard from the unit. On the bottom of the splash guard, you will find a label
detailing the wire connection to pin number assignments, which are repeated in the table
below.
Pin # Signal Name Connection
1 P0+ Pressure Transducer 0 (positive terminal)
2 P0- Pressure Transducer 0 (negative terminal)
3 P1+ Pressure Transducer 1 (positive terminal)
4 P1- Pressure Transducer 1 (negative terminal)
5 P2+ Pressure Transducer 2 (positive terminal)
6 P2- Pressure Transducer 2 (negative terminal)
7 P3+ Pressure Transducer 3 (positive terminal)
8 P3- Pressure Transducer 3 (negative terminal)
9 P4+ Pressure Transducer 4 (positive terminal)
10 P4- Pressure Transducer 4 (negative terminal)
11 P5+ Pressure Transducer 5 (positive terminal)
12 P5- Pressure Transducer 5 (negative terminal)
Please refer to Figure 7 for connecting the FPM100 to a pressure transducer. This figure
shows the connection of the pressure transducer to channel 0 via the terminals named P0+
and P0-. Connections to other channels are similar.
Pressure Transducer
FPM100 Screw Terminals
Red
Black or White
1 2
P0+
P0-
5 4 3 6 7 8 9 10 11 12
P1-
P1+
P2+
P2-
P3+
P3-
P4+
P4-
P5+
P5-
Figure 7 – Pressure Transducer Connection Diagram
Page 8 Revision 1.3