Filter
Top Products
9-14
9.2.7. Setting the SD PCB, Heat Sink and FAN Motor
1. Connect the SD FFC to the Connector (CN1401).
2. Fix the SD PCB to the computer using the three
Screws<N9>.
3. Set the Heat Sink, Fan Duct and the four Heat Sink
Springs.
4. Fix the FAN Motor to the computer using the two
Screws<N5>.
5. Attach the Fan Tape 1 and 2 on the FAN Motor, and fix
the Cable Holder on them.
Screws <N5>: DXSB2+6FNL
Screws <N9>: DFHE5025XA
Q Applying Grease on the Heat Sink
1. Apply grease on two points of the Heat Sink.
2. Attach the Pipe Sheet on the Heat Pipe.
Cable Holder
<N5>
FAN Motor
Heat Sink
Fan Duct
Fan Tape1
Fan Tape2
Heat Sink
Spring
Heat Sink
Spring
<N9>
SD PCB
CN1401
SD FFC
Grease is applied.
Fan Dust Sheet
Fan Dust Sheet
0~1mm
G751(10mmX10mmXt0.3)
Grease is applied.
G751(10mmX10mmXt0.3)
0~1mm
0~1mm
0~1mm
5~10mm
Pipe Sheet
Heat Sink
(Attach the Fan Duct Sheet
to the back side.)
Match the end of the Pipe Sheet.
(0 ~ -2mm)
Fold on the center line
and attach it.