Filter
Top Products
8
INST
ALLATION
8. Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on
cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road
vibration or sudden vehicle stops.
9. Connect source signal by plugging the RCA cables into the input jacks at the amplifier.
CAUTION: Always ensure power is off or disconnected at the amplifier before connecting
RCA cables. Failure to do so may cause injury, damage to the amplifier and/or
connected components.
10. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker plug connector and tighten
the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT chassis ground
any of the speaker leads as unstable operation may result.
11. Perform a final check of the completed system wiring to ensure that all connections are accurate. Check
all power and ground connections for frayed wires and loose connections which could cause problems.
12. Ensure the amplifier is mounted securely and reinstall the end cover. Install an inline fuse near the
battery connection.
NOTE: Follow the diagrams for proper signal polarity.
CAUTION: These amplifiers are not recommended for impedance loads below 2 stereo
and 4 bridged.
CAUTION: Do not attempt to connect the source units speaker leads directly to the RCA
connections of this amplifier, as damage to the source unit and/or the
amplifier may result.
2-Channel Wiring
• RCA Inputs connect to FRONT inputs only.
• 2/4 CH SWITCH push in to set to 2CH.
• Gain (Front & Rear) - is set independently to
suit application.
• Crossover (Front & Rear) - is set independently
to suit application.